Cisco UCS B200 M4 Note d'installation et d'entretien - Page 25
Parcourez en ligne ou téléchargez le pdf Note d'installation et d'entretien pour {nom_de_la_catégorie} Cisco UCS B200 M4. Cisco UCS B200 M4 30 pages. For e5-2600 v4 series cpus
Également pour Cisco UCS B200 M4 : Note d'installation et d'entretien (46 pages), Manuel de mise à jour (9 pages), Manuel d'entretien (24 pages)
Imprimer la page
Installing an Adapter Card
The network adapters and interface cards all have a shared installation process and are constantly being updated. A list of currently
supported and available models for this server is in the specification sheets at this URL:
http://www.cisco.com/en/US/products/ps10280/products_data_sheets_list.html
The UCS B200 M4 blade server has two adapter slots that support the following VIC cards:
• VIC 1340 and VIC 1380
• VIC 1240 and VIC 1280
Slot 1 is for the VIC 1340 or VIC 1240 cards. Slot 2 is for the VIC 1380 and VIC 1280 cards, and can also be used for the VIC port
expander, third-party CNA cards, and non-I/O mezzanine cards, such as Fusion IO.
The VIC 1340 and VIC 1380 require a Cisco UCS 6200 Series Fabric Interconnect, and they support the Cisco Nexus 2208XP and
2204XP Fabric Extender (FEX) modules.
The VIC 1240 and VIC 1280 support Cisco UCS 6200 and 6100 Series Fabric Interconnects, and they support the Cisco Nexus
2208XP, 2204XP, and 2104XP Fabric Extender (FEX) modules. When a VIC 1240 or 1280 is used with a UCS 6100 Series Fabric
Interconnect, the UCS B200 M4 blade server requires a minimum software release of 2.2 for Cisco UCS Manager.
If you are switching from one type of adapter card to another, before you physically perform the switch make sure that you download
the latest device drivers and load them into the server's operating system. For more information, see the firmware management chapter
of one of the Cisco UCS Manager software configuration guides.
The Cisco Fusion-io Drive mezzanine adapter cards can be installed and removed using the same procedures. Using these drives in
a B200 M4 blade server requires the presence of a VIC 1340 or VIC 1240 mLOM to provide blade I/O. They will not work in M1
and M2 generations Cisco UCS servers. These drives appear in Cisco UCS Manager as regular SSD drives.
Procedure
Step 1
Position the adapter board connector above the motherboard connector and align the two adapter captive screws to the
standoff posts on the motherboard.
Step 2
Firmly press the adapter connector into the motherboard connector (callout 2).
Step 3
Tighten the two captive screws (callout 3).
25