Cisco UCS B460 M4 Note d'installation et d'entretien - Page 24

Parcourez en ligne ou téléchargez le pdf Note d'installation et d'entretien pour {nom_de_la_catégorie} Cisco UCS B460 M4. Cisco UCS B460 M4 46 pages. Blade server
Également pour Cisco UCS B460 M4 : Fiche technique (7 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (5 pages), Note d'installation et d'entretien (50 pages)

Removing an SSD Drive

To remove a drive from a blade server, follow these steps:

Procedure

Step 1

Press the latch inward on the drive front panel. See callout 1 in the following figure.

Step 2

Pull the drive from the slot. See callout 2 in the following figure.

Figure 7: Removing an SSD

Step 3

Place the drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another

blade server.

Step 4

Install a blanking panel (N20-BBLKD-7MM) if the slot will remain empty.

To install an SSD drive in the blade server, follow these steps:

Procedure

Step 1

Remove the blanking panel, if necessary.

Step 2

With the drive label face up, align the drive with the desired drive bay and insert.

Step 3

Gently slide the drive into the opening in the blade server until the SSD clicks into place and the latch fully

engages.

Step 4

Check the LEDs on the blade server to make sure the drive is functioning as expected.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

Servicing the Blade Server