Cisco UCS B460 M4 설치 및 서비스 참고 사항 - 페이지 24

{카테고리_이름} Cisco UCS B460 M4에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B460 M4 46 페이지. Blade server
Cisco UCS B460 M4에 대해서도 마찬가지입니다: 데이터시트 (7 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (5 페이지), 설치 및 서비스 참고 사항 (50 페이지)

페이지 인쇄

Removing an SSD Drive

To remove a drive from a blade server, follow these steps:

Procedure

Step 1

Press the latch inward on the drive front panel. See callout 1 in the following figure.

Step 2

Pull the drive from the slot. See callout 2 in the following figure.

Figure 7: Removing an SSD

Step 3

Place the drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another

blade server.

Step 4

Install a blanking panel (N20-BBLKD-7MM) if the slot will remain empty.

Installing an SSD Drive

To install an SSD drive in the blade server, follow these steps:

Procedure

Step 1

Remove the blanking panel, if necessary.

Step 2

With the drive label face up, align the drive with the desired drive bay and insert.

Step 3

Gently slide the drive into the opening in the blade server until the SSD clicks into place and the latch fully

engages.

Step 4

Check the LEDs on the blade server to make sure the drive is functioning as expected.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

Servicing the Blade Server