Cisco ASR 9000 Series Manuel de configuration - Page 35
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco ASR 9000 Series. Cisco ASR 9000 Series 50 pages. Line card
Également pour Cisco ASR 9000 Series : Configuration des paramètres du réseau (26 pages), Manuel de configuration (46 pages), Manuel (24 pages), Configuration (46 pages), Manuel (44 pages), Manuel de référence rapide (7 pages)
Imprimer la page
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Command or Action
Step 9
Repeat Step 1 through Step 7 to configure the PVC at
the other end of the AC.
Step 10
show policy-map interface serial
interface-path-id.subinterface {input | output}
or
show policy-map type qos interface serial
interface-path-id.subinterface {input | output}
Example:
RP/0/0RP0/CPU0:router# show policy-map
interface pos 0/1/0/0.1 output
or
RP/0/0RP0/CPU0:router# show policy-map type qos
interface pos 0/1/0/0.1 output
What to Do Next
•
•
•
•
Configuring IPHC
This section contains the following step procedures:
•
•
•
•
•
Prerequisites for Configuring IPHC
IP header compression (IPHC) is supported on the following cards:
•
OL-26061-03
To configure a point-to-point pseudowire XConnect on the AC you just created, see the
"Implementing Layer 2 Tunnel Protocol Version 3" module of the Cisco IOS XR Virtual Private
Network Configuration Guide for the Cisco CRS Router.
To configure an L2VPN, see the "Implementing MPLS Layer 2 VPNs" module of the Cisco IOS XR
Virtual Private Network Configuration Guide for the Cisco CRS Router.
To configure a point-to-point pseudowire XConnect on the AC you just created, see the
"Implementing Layer 2 Tunnel Protocol Version 3 on Cisco IOS XR Software" module of the Cisco
IOS XR Virtual Private Network Configuration Guide for the Cisco XR 12000 Series Router.
To configure an L2VPN, see the "Implementing MPLS Layer 2 VPNs on Cisco IOS XR Software"
module of the Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco XR 12000
Series Router.
Prerequisites for Configuring IPHC, page 533
Configuring the IPHC Slot Level Command, page 534
Configuring an IPHC Profile, page 536
Configuring an IPHC Profile, page 538
Enabling an IPHC Profile on an Interface, page 541
Cisco 1-Port Channelized OC-12/STM-4
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Brings up the AC.
Note
The configuration on both ends of the connection
must match.
(Optional) Displays the statistics and the configurations of
the input and output policies that are attached to a
subinterface.
How to Configure Serial Interfaces
533