Cisco ASR 9000 Series Configuration - Page 22

Parcourez en ligne ou téléchargez le pdf Configuration pour {nom_de_la_catégorie} Cisco ASR 9000 Series. Cisco ASR 9000 Series 46 pages. Line card
Également pour Cisco ASR 9000 Series : Configuration des paramètres du réseau (26 pages), Manuel de configuration (46 pages), Manuel de configuration (50 pages), Manuel (24 pages), Manuel (44 pages), Manuel de référence rapide (7 pages)

Imprimer la page
Cisco ASR 9000 Series Configuration
How to Configure Channelized SONET/SDH
Command or Action
Step 14
no shutdown
Example:
RP/0/RSP0/CPU0:router(config-if)# no
shutdown
Step 15
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-sonet)# end
or
RP/0/RSP0/CPU0:router(config-sonet)#
commit
Step 16
show controllers sonet interface-path-id
Example:
RP/0//RSP0/CPU0:router# show controllers
sonet 0/1/1/0

Configuring Channelized SONET APS

This task explains how to configure APS for channelized SONET lines.
Prerequisites
•
•
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
HC-338
You should know how to configure the SONET controller as specified in the
Clear Channel SONET Controllers"
on the Cisco ASR 9000 Series Router
You should know how to configure the SONET APS as specified in the
section of the
Configuring Clear Channel SONET Controllers on the Cisco ASR 9000 Series Router
module.
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Purpose
Removes the shutdown configuration.
Note
Removal of the shutdown configuration eliminates the
forced administrative down on the interface, enabling it to
move to an up or down state (assuming that the parent
SONET layer is not configured administratively down).
Saves configuration changes.
When you issue the end command, the system prompts you to
•
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the running
–
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
–
router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
Use the commit command to save the configuration changes to
•
the running configuration file and remain within the
configuration session.
Verifies the SONET controller configuration.
section of the
Configuring Clear Channel SONET Controllers
module.
"How to Configure
"Configuring SONET APS"
OL-26061-03