Cisco EVM-IPVS-16A Connexion - Page 10

Parcourez en ligne ou téléchargez le pdf Connexion pour {nom_de_la_catégorie} Cisco EVM-IPVS-16A. Cisco EVM-IPVS-16A 15 pages. Analog video gateway network modules

Imprimer la page

How to Install, Connect, or Replace the EVM-IPVS-16A Network Module

Connect the other end of the wired terminal block connectors to the RS-485 and contact closure devices

Step 4

in your network. In most cases, the wires will be connected to a patch panel.

Step 5

(Optional) To connect the EVM-IPVS-16A network module to an external device, use a straight-through

two-pair Category 5e unshielded twisted-pair (UTP) cable, and connect the RJ-45 Gigabit Ethernet port

on the network module to a switch, hub, repeater, server, or other Gigabit Ethernet network device.

What to Do Next

Proceed to the software configuration for your EVM-IPVS-16A network module. See the Cisco Analog

Video Gateway 1.0 Installation and Upgrade Guide at:

http://www.cisco.com/en/US/docs/video/cavg/cavginstall/cavginstall.html

Performing Online Insertion and Removal of the EVM-IPVS-16A Network

Module

The online insertion and removal (OIR) feature enables some Cisco modular access routers to support

the replacement of network modules without switching off the router or affecting the operation of other

interfaces. Also, routing information is maintained during OIR of network modules.

If your router does not support OIR, do not perform this task to replace your EVM-IPVS-16A network

Note

module. Instead, see the Installing Cisco Network Modules in Cisco Access Routers guide at:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNetM.

html

Restrictions

•

Steps

To perform OIR of the EVM-IPVS-16A network module in your router, follow these steps:

Initiate a console session with your router.

Step 1

Enter configuration mode and shut down the interface:

Step 2

Router> enable

Router# configure terminal

Router(config)# interface video-Service-Engine

Router(config-if)# shut

Router(config-if)# shutdown

Router(config-if)# exit

Connecting Cisco Analog Video Gateway Network Modules to the Network

Only the Cisco 3845 router supports OIR of the EVM-IPVS-16A network module.

All connections made through the EVM-IPVS-16A network module are reset during OIR.

You must perform OIR with similar modules. If you remove a network module, install another

network module exactly like it in its place.

Connecting Cisco Analog Video Gateway Network Modules to the Network

slot