Cisco Physical Access CIAC-GW-K9 Installation et configuration - Page 14
Parcourez en ligne ou téléchargez le pdf Installation et configuration pour {nom_de_la_catégorie} Cisco Physical Access CIAC-GW-K9. Cisco Physical Access CIAC-GW-K9 26 pages. Physical access gateway
Également pour Cisco Physical Access CIAC-GW-K9 : Manuel de démarrage rapide (17 pages)
Imprimer la page
Installing the Cisco Physical Access Gateway
Connect the Gateway to the IP network by connecting an Ethernet cable to the ETH0 port, as shown in
Step 7
Figure
Figure 2-11
1
Step 8
Continue to the
page
2-24.
Cisco Physical Access Gateway User Guide
2-14
2-11.
ETH 0 Ethernet Connection for the Cisco Physical Access Gateway
1
ETH0—Ethernet port for connecting the Gateway to the IP network.
The ETH0 connection can also be used for Power over Ethernet.
Note
Note
The ETH1 port is used to connect a PC to the Gateway for configuration and monitoring.
See the
"Configuring and Managing the Gateway Using a Direct Connection" section on
page 2-15
for more information.
"Configuring the Gateway Using the Cisco Physical Access Manager" section on
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
OL-32499-01