- ページ 14
ゲートウェイ Cisco Physical Access CIAC-GW-K9のPDF インストールと設定をオンラインで閲覧またはダウンロードできます。Cisco Physical Access CIAC-GW-K9 26 ページ。 Physical access gateway
Cisco Physical Access CIAC-GW-K9 にも： クイック・スタート・マニュアル (17 ページ)
ページを印刷する
Installing the Cisco Physical Access Gateway
Connect the Gateway to the IP network by connecting an Ethernet cable to the ETH0 port, as shown in
Step 7
Figure
Figure 2-11
1
Step 8
Continue to the
page
2-24.
Cisco Physical Access Gateway User Guide
2-14
2-11.
ETH 0 Ethernet Connection for the Cisco Physical Access Gateway
1
ETH0—Ethernet port for connecting the Gateway to the IP network.
The ETH0 connection can also be used for Power over Ethernet.
Note
Note
The ETH1 port is used to connect a PC to the Gateway for configuration and monitoring.
See the
"Configuring and Managing the Gateway Using a Direct Connection" section on
page 2-15
for more information.
"Configuring the Gateway Using the Cisco Physical Access Manager" section on
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
OL-32499-01