Epson Perfection V350 Series Manuel de l'utilisateur - Page 5

2. Make sure the film strip is placed as shown.

3. Scanning the first 3 frames of the film strip:

Place the film holder on the document table so that it is

aligned as shown. Make sure the tab labelled "B" on the film

holder fits into the area labelled "B" on the scanner.

Scanning the last 3 frames of the film strip:

Remove the film strip from the film holder, then re-insert it

with the last frame first. Place the film holder on the

document table so that it is aligned as shown below.

4. Close the scanner cover.

When you are finished scanning film, be sure to replace the

document mat before scanning documents or photos. See

page 8.

Placing Film in the Auto Film Loader

The Perfection V350 Photo comes with an auto film loader on

the scanner cover that lets you load a film strip for scanning

automatically. Before loading a filmstrip in the auto film loader,

however, make sure it meets these requirements to avoid

damaging your film or the film loader:

❏ The film is dry.

❏ The film is not infrared film.

❏ The film is 35 mm wide and 2.9 to 9.1 inches (74 to

232 mm) long.

❏ The film strip contains at least 2 photos, but no more

than 6.

❏ The film has no damaged edges or holes along the sides.

❏ The film has no folds, ripples, bends, or curls.

❏ The film has no stickers on it. If there is a sticker on the film

strip away from the image, you can carefully cut off the part

with the sticker.

Note: If you want to scan film that does not meet these

requirements, use the film holder, instead. See "Placing Film in the

Holder" on page 4.

8/06

Epson Perfection V350 Photo

Epson Perfection V350 Photo - 5