Crow FW2-SIREN2EXT-8/9F Manuel d'installation - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Crow FW2-SIREN2EXT-8/9F. Crow FW2-SIREN2EXT-8/9F 19 pages. Siren system
Imprimer la page
- User Guide
5. Use a 8 mm bit to drill the holes
6. Fix the unit onto the installation surface.
7. Ensure that the Piezo Siren is connected to the Piezo connector (as shown
below).
8. Insert the battery into the battery clip and connect it to the BAT connector
(shown above).
Note: The battery shall be Installed/replaced by service man
The Siren will beep once and then the LED power will blink for a period of 30 seconds,
please wait to the end of the blinking before activating or learning.
Battery
Address Jumpers
12 Volt Connector
PIEZO Siren Connector
Battery Connector
Figure 5: Siren Connectors
Figure 4: Open Siren Unit
13