Crow FW2-SIREN2EXT-8/9F Installatiehandleiding - Pagina 15

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Crow FW2-SIREN2EXT-8/9F. Crow FW2-SIREN2EXT-8/9F 19 pagina's. Siren system

- User Guide

5. Use a 8 mm bit to drill the holes

6. Fix the unit onto the installation surface.

7. Ensure that the Piezo Siren is connected to the Piezo connector (as shown

below).

8. Insert the battery into the battery clip and connect it to the BAT connector

(shown above).

Note: The battery shall be Installed/replaced by service man

The Siren will beep once and then the LED power will blink for a period of 30 seconds,

please wait to the end of the blinking before activating or learning.

Battery

Address Jumpers

12 Volt Connector

PIEZO Siren Connector

Battery Connector

Figure 5: Siren Connectors

Figure 4: Open Siren Unit