Epson Stylus Photo 820 Instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Epson Stylus Photo 820. Epson Stylus Photo 820 5 pages. Product support bulletin(s)
Également pour Epson Stylus Photo 820 : Fiche technique (1 pages), Note de programmation (18 pages), Bulletin d'information sur les produits (6 pages), Bulletin d'information sur les produits (1 pages), Manuel complémentaire (1 pages), Manuel de l'utilisateur (27 pages), Manuel de compatibilité (1 pages), Commencer ici (2 pages), Fiche d'information sur le produit (4 pages), Spécifications (2 pages), Informations sur le produit (11 pages), Spécifications (2 pages), Bulletin d'information sur les produits (3 pages), Bulletin d'information sur les produits (2 pages), Bulletin d'information sur les produits (4 pages), Bulletin d'information sur les produits (7 pages)

Imprimer la page
Epson Stylus Photo 820 Instructions d'installation
Trim each tube length so that the tube will make a turn into the bottle without rising up. There must be 3
inch of tubing inside the bottle. When you cut the tube, cut on a 45 degree angle so the end of the tube is
pointed. After you cut the tubes to length, use a black marker and make a mark on each tube 3
the end of the tube. Insert the tubes through the larger hole in the center of the cap until the black mark is
just inside the cap. Don't cut the tubes too short.
Be sure to get the right color tube into the right ink bottle – follow tube from cart to bottle to be sure.
Maiden Voyage
10. Okay, now everything is put together. Double check your cartridges, they may have become lose during the
assembly steps above. Reseat them, make sure they are down all the way. Some black electrical tape to
hold them down is not a bad idea. If they pop up slightly you will have red light problems.
Push the cartridges to the far right until they stop. Plug the printer in, and turn on the power. Watch for
anything unusual. You are ready to start printing.
11. Run 3 cleaning cycles. Print a couple of copies of purger6.tif, found on the diskette.
begin to climb up the tubes. They will not all rise at the same rate. If you have banding or incomplete
printing, run cleaning cycles in groups of 3. Always do a nozzle check before and after each cleaning. As
soon as you have a good nozzle check, you are ready to start using the system. As you print, the inks will
continue their climb until they reach the cartridge. Don't worry if the inks seem to be moving slowly, they will
all get to the cartridge eventually. If you have trouble getting a good nozzle check, let the system rest for a
few hours or overnight, then try again in the morning.
Auto Reset Chips or F-16 Resetter
12. There is no way to turn off the Epson ink monitoring system. As you print, the monitoring system counts the
input to the cartridge and will eventually report that the cartridge is empty. Actually the CFS keeps the ink
level in the cartridge constant so it will never be empty. However, the monitoring system thinks it is using up
ink and will show you a graphic of what it thinks is the ink level.
side
Never Lift Your Cartridges Up
back
¾
back
The inks should
¾
inch from