Epson Stylus Photo 820 Kurulum Talimatları - Sayfa 4

Yazıcı Aksesuarları Epson Stylus Photo 820 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Epson Stylus Photo 820 5 sayfaları. Product support bulletin(s)
Ayrıca Epson Stylus Photo 820 için: Şartname Sayfası (1 sayfalar), Programlama Notu (18 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürün Destek Bülteni (1 sayfalar), Tamamlayıcı Kılavuz (1 sayfalar), Kullanıcı Kılavuzu (27 sayfalar), Uyumluluk Kılavuzu (1 sayfalar), Buradan başlayın (2 sayfalar), Ürün Bilgi Formu (4 sayfalar), Teknik Özellikler (2 sayfalar), Ürün Bilgileri (11 sayfalar), Teknik Özellikler (2 sayfalar), Ürün Destek Bülteni (3 sayfalar), Ürün Destek Bülteni (2 sayfalar), Ürün Destek Bülteni (4 sayfalar), Ürün Destek Bülteni (7 sayfalar)

Trim each tube length so that the tube will make a turn into the bottle without rising up. There must be 3

inch of tubing inside the bottle. When you cut the tube, cut on a 45 degree angle so the end of the tube is

pointed. After you cut the tubes to length, use a black marker and make a mark on each tube 3

the end of the tube. Insert the tubes through the larger hole in the center of the cap until the black mark is

just inside the cap. Don't cut the tubes too short.

Be sure to get the right color tube into the right ink bottle – follow tube from cart to bottle to be sure.

Maiden Voyage

10. Okay, now everything is put together. Double check your cartridges, they may have become lose during the

assembly steps above. Reseat them, make sure they are down all the way. Some black electrical tape to

hold them down is not a bad idea. If they pop up slightly you will have red light problems.

Push the cartridges to the far right until they stop. Plug the printer in, and turn on the power. Watch for

anything unusual. You are ready to start printing.

11. Run 3 cleaning cycles. Print a couple of copies of purger6.tif, found on the diskette.

begin to climb up the tubes. They will not all rise at the same rate. If you have banding or incomplete

printing, run cleaning cycles in groups of 3. Always do a nozzle check before and after each cleaning. As

soon as you have a good nozzle check, you are ready to start using the system. As you print, the inks will

continue their climb until they reach the cartridge. Don't worry if the inks seem to be moving slowly, they will

all get to the cartridge eventually. If you have trouble getting a good nozzle check, let the system rest for a

few hours or overnight, then try again in the morning.

Auto Reset Chips or F-16 Resetter

12. There is no way to turn off the Epson ink monitoring system. As you print, the monitoring system counts the

input to the cartridge and will eventually report that the cartridge is empty. Actually the CFS keeps the ink

level in the cartridge constant so it will never be empty. However, the monitoring system thinks it is using up

ink and will show you a graphic of what it thinks is the ink level.

side

Never Lift Your Cartridges Up

back

The inks should

inch from