Aculux CTA4-125 Instructions d'installation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Aculux CTA4-125. Aculux CTA4-125 2 pages. Ceiling thickness adapter

Imprimer la page

A. STANDOFF TO HOUSING ASSEMBLY

STEP 1:

• Turn off power to fixture.

• Remove lens ring assembly 1 from unit.

• Remove three mounting screws 2 from

mounting ring 3 .

• Remove mounting ring 3 and put it

aside.

B. CHOOSE FOR CTA4-125 OR CTA4-200

FOR CTA4-125

1. Install adapter over Trim:

Install adapter over trim by holding

torsion springs together to get ring over

trim. Wider diameter of adapter ring

faces down. Completed assembly

should look like picture shown below.

WARRANTY

Juno Lighting Group warrants that its products are free from defects in material and workmanship. Juno Lighting Group's obligation

is expressly limited to repair or replacement, without charge, at Juno Lighting Group's factory after prior written return authorization has been

granted. This warranty shall not apply to products which have been altered or repaired outside of Juno Lighting Group's factory. This warranty

is in lieu of all other warranties, expressed or implied, and without limiting the generality of the foregoing phrase, excludes any implied warranty

of merchantability. Also, there are no warranties which extend beyond the description of the product on the company's literature setting forth

terms of sale.

Product Services Phone (888) 387-2212

1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com

INSTALLATION INSTRUCTIONS

FOR CEILING THICKNESS ADAPTER

STEP 2:

• Install three standoffs 4 provided with

male threaded end into housing 5 .

• Place mounting ring 3 on top of the

three standoffs 4 .

• Attach mounting ring 3 to standoffs 4

with the three screws 2 removed in

Step 1.

• Snap the lens ring assembly 1 into the

mounting ring 3 and adjust the lamp aim

to desired position.

• Remove the lens ring assembly 1 from

mounting ring 3 to gain access to thumb

screw to secure lamp aim position.

• Snap the lens ring assembly 1 to the

mounting ring 3 .

FOR CTA4-200

1. Remove two torsion springs

Springs can be removed by bending the

coil backward or cutting the springs from

trim. Trim should look like picture below

when complete.

2. Attach adapter to trim

Slide adapter over shoulder rivets and

turn clockwise to lock adapter in place.

Printed in USA

Rev 06/08

P4028-02

pg 1 of 2