Epson Stylus Pro 4880 Portrait Edition Manuel de configuration - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Epson Stylus Pro 4880 Portrait Edition. Epson Stylus Pro 4880 Portrait Edition 16 pages. Warranty statement
Également pour Epson Stylus Pro 4880 Portrait Edition : Brochure (1 pages), Fiche technique (6 pages), Brochure & Specs (6 pages), Manuel de référence rapide (12 pages), Manuel du réseau (46 pages), Manuel d'installation (4 pages), Manuel d'information sur les produits (16 pages), Garantie limitée (12 pages)

3. Raise the ink levers.

4. Remove the package from an ink cartridge,

and then shake the ink cartridge well for best

results.

5. Hold the ink cartridge with the arrow mark

facing up and pointing to the rear of the

printer, and then insert it in the slot.

6. Repeat steps 4 to 5 to install the other ink

cartridges.

7. After inserting all ink cartridges in their

corresponding slot, lower the ink levers. The

printer starts initial ink charging.

8. After approximately two minutes, ink lever

messages appear on the LCD panel. Raise or

lower the ink levers accordingly until READY

appears on the LCD panel, which indicates

initial ink charging is completed.

Caution:

Never perform the following tasks while the

Pause light is flashing; otherwise, damage

may occur.

❏ Turn off the printer.

❏ Open the top cover.

❏ Remove the rear cover.

❏ Move the paper lever to the released

position.

❏ Remove the ink cartridges.

❏ Remove the maintenance tank.

❏ Unplug the power cord.

9. Close the ink compartment cover(s).

Note:

If you have installed 220 ml ink cartridges, do not

close the ink compartment cover(s).