Epson Stylus Pro 7600 Manuel de référence rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} Epson Stylus Pro 7600. Epson Stylus Pro 7600 11 pages. W 24-inch-wide and 44-inch-wide photographic
printers with new seven-color ultrachrome ink system
Également pour Epson Stylus Pro 7600 : Manuel de déballage et d'installation (24 pages), Manuel (5 pages)
Imprimer la page
If you notice banding or missing colors in your printouts,
the print head may need cleaning. First print a nozzle
check pattern to find out the condition of the print head.
Then run a cleaning cycle, if neccessary, and print another
check pattern to test the results.
1
Load a sheet of coated ink jet paper (or roll paper)
in the printer.
2
Press the SelecType button, then press the
button so that TEST PRINT appears on the
display.
3
Press the
button twice, then press Enter. The
nozzle check prints as shown:
If all the lines in the nozzle check are complete, with
no missing dots or gaps, the print head doesn't need
cleaning.
If the pattern is missing dots or lines, as shown below,
you need to run a cleaning cycle.
4
5
INCH
MM
6
If You Notice Banding...
If you still see banding after running a cleaning cycle, you
may need to align the print head as described in the
Printer Guide.
Banding can also be caused by selecting the incorrect
paper type in your printer software. Be sure to select the
paper you're using in the EPSON printer software or in a
third-party RIP. If your paper is not listed, you can use the
printer's SelecType menu to create a custom paper type
(see "Optimizing the Settings for Your Paper" in the
Printer Guide).
4
Make sure all the Ink Out lights on the printer's
control panel are off. If an Ink Out light is
flashing or on, you need to replace the
corresponding ink cartridge instead.
Press the Cleaning button and hold it for at least
3 seconds. The Pause light flashes as the printer
cleans its print head. The cleaning cycle takes
about a minute and does not use any paper.
To avoid damaging the printer, don't turn it off
until the cleaning cycle is finished and the
Pause light has stopped flashing.
When the Pause light goes off, follow steps
1 through 3 to run another nozzle check to make
sure the print head is clean.