Philips AZ1826 Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Philips AZ1826. Philips AZ1826 13 pages. Cd soundmachine
Également pour Philips AZ1826 : Fiche technique (2 pages), Manuel d'utilisation rapide (2 pages), Manuel d'utilisation rapide (1 pages), Manuel d'utilisation rapide (2 pages)
Imprimer la page
TROUBLESHOOTING
WARNING
Do not open the set as there is a risk of electric shock! Under no circumstances should you try to
repair the set yourself, as this will invalidate the guarantee.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Remote control does not function properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle
No sound /power
– Volume not adjusted
• Adjust the VOLUME
– Power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Severe radio hum or noise
– Electrical interference: set too close to TV, VCR or
computer
• Increase the distance
Poor radio reception
– Weak radio signal
• FM: Adjust the FM telescopic aerial
indication
– It is set in the USB mode.
• Press CD/USB to select CD mode.
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R/CD-RW is blank/ not finalized
• Use a finalized CD-R(W)
– CD-ROM disc inserted/
CD contains non-audio files
• Use CD Audio discs/MP3-CD only/
press ∞ or § once or more to skip to a CD audio
track instead of the data files
Note:
Make sure the CD is not encoded with
Copyright protection technologies, as some do
not conform to the Compact Disc standard.
The disc skips tracks
– Disc damaged or dirty
• Replace or clean disc
– SHUF or PROG is active
• Switch off SHUF/PROG
Note:
DRM-protected WMA is not supported.
Sound skips during MP3 playback
– MP3 file made at compression level exceeding
320kbps
• Use a lower compression level to record CD
tracks into MP3 format
– Disc damaged or dirty
• Replace or clean disc
The USB device doesn't play on my AZ1826.
– It is not set in the USB mode.
• Press CD/USB to select USB mode.
– The device is not securely connected to AZ1826's USB
port.
• Re-connect the device, and make sure that the device
is powered on.
– The device is not supported by AZ1826, or the audio
file format stored on the device is not supported by
AZ1826.
• Use a compatible device/ playable audio file format.
I cannot use the remote control to select CD or
USB.
– The main unit is not set in CD/USB mode
• On the main unit, push Source selector to CD/USB
position, then use the remote control to select CD or
USB.