3Com 7250 Manuel de démarrage rapide - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} 3Com 7250. 3Com 7250 9 pages. Converting to managed access point operation
Également pour 3Com 7250 : Fiche technique (4 pages), Manuel de conversion (10 pages)
Imprimer la page
If you have routed the Ethernet cable through the center opening, secure the cable on the
hook located on the mounting plate as shown in the illustration below.
2
Connect the Ethernet cable to the Ethernet port on the access point.
3
Connect the power cable to the power port on the rear panel of the access point.
4
Position the access point at an angle to the mounting plate bayonet connection and turn the
unit clockwise until it snaps into place, as shown below.
Top opening
Center opening
6
Flat Surface Installation
1
Find a clean and dry surface that is elevated enough to provide good reception and coverage
for the network. Do not place the access point on a metal surface.
2
Make sure to choose a location where the access point will not be disturbed.
3
Connect the Ethernet cable into the Ethernet port.
4
Connect the power cable to the power port on the rear panel of the access point.
5
Set the access point down on a flat, level surface.
Hook for securing
the cable
Align with mounting plate
and rotate clockwise to lock
6