CRU Dataport Data Express DE110 Ultra ATA133 Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CRU Dataport Data Express DE110 Ultra ATA133. CRU Dataport Data Express DE110 Ultra ATA133 2 pages.

Imprimer la page

Data Express DE110 Ultra ATA133

Removable Ultra ATA133 Drive Enclosure

NOTES: For Ultra ATA133 (133MByte/sec) operation, an Ultra ATA133 controller

and hard drive (s), and appropriate 40-pin, 80-conductor cable are required.

Receiving Frame Motherboard

Master/Slave Selection Jumper (ID0 & ID1) - Master Drive

designation (jumper is factory-installed on ID0). Change jumper

position to Pins 3 & 4 (ID1) for Slave Drive designation.

Forces Master/Slave Drive configuration on the receiving frame, if

jumper option on the drive itself is configured for Cable Selection

(recommended configuration). Refer to section "Master/Slave Drive

Section" for further information.

If using the Drive Select Method, this option is instead used to

configure the unit ID display only (refer to section "Master/Slave

Drive Section" for further information).

Remote Activity LED (RLED) - These pins provide power for a re-

mote LED device activity indicator (Pin 13 = Cathode, Pin 14 = Anode).

Factory Reserved Pins - These pins are reserved for factory use

only - Do not install jumper under any circumstances!

DC Power

Connector (P1)

I/O Connector

Factory Reserved Pins

(JP1)

(no jumper installed)

Figure 1: Receiving Frame Motherboard (Rear View)

Master/Slave Drive Selection

There are two ways to set the Master/Slave Drive designation for the

DE110 unit, as described below.

1. Cable Select Method (Recommended Method): In most cases,

the drive will be factory configured as a Master Drive using a

jumper option on the drive itself. CRU-DataPort, recommends

reconfiguring the drive for Cable Select. This can be done by configuring

the jumper on the drive itself (refer to the drive manufacturer's

documentation for further information).

Option Pin

Master Drive

Connector (W1)

Select (ID0) (factory

installed jumper)

Slave Drive Select

(ID1)

= Pin 1

Rugged, Reliable, Mobile, Secure

When the drive is jumpered as double select, the Master/Slave

designation is handled by the Master/Slave Selection Jumper Option

(ID0 & ID1) located on the receiving frame motherboard. If neces-

sary, reconfigure jumper (jumper is factory-configured for Master

Drive designation). Skip "Drive Select Method" and continue with the

Installation process.

2. Drive Select Method: In most cases, the drive will be factory

configured as a Master Drive using a jumper option on the drive

itself. Reconfigure the jumper if necessary (refer to the drive

manufacturer's documentation for exact Master/Slave jumper

settings).

Reconfigure the jumper (jumper is factory installed on ID0 for Master

Drive designation) on the receiving frame motherboard to match the

hard drive.

NOTE: Since specifications (specifically, pin assignments)

between drive manufacturers may vary, please refer to your

drive manufacturer's documentation for exact information

regarding Master/Slave and Cable Select configuration.

Installation

1. Attach the DC power cable (from the drive carrier board) to the drive.

2. Carefully insert drive into the carrier. Slide the drive towards the

Drive Carrier Board, so that the I/O connector on the drive mates

with the connector on the Drive Carrier Board. Make sure that the

DC power cable is not pinched. Turn the drive/carrier assembly over.

3. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd.

screws. Some drives may require minor adjustment before securing

into carrier with screws.

4. Install the provided drive cover.

1-800-260-9800