Dimplex XLS24N Manuel d'utilisation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dimplex XLS24N. Dimplex XLS24N 10 pages. Ultra-slim storage heaters
Également pour Dimplex XLS24N : Mode d'emploi (4 pages), Manuel d'instructions d'installation (8 pages), Mode d'emploi (4 pages), Manuel d'instructions d'installation (8 pages), Manuel d'instructions d'installation (8 pages)
Imprimer la page
'OUTPUT' boost heating control
Models XL12N, XL18N, XL24N, XLS12N,
XLS18N, XLS24N only.
This controls the airflow release through the heater and can be
6
used to release heat faster or as a boost of heat later in the day.
Depending upon the amount of charge accepted by the heater, the
oUTPUT control allows the release of additional heat,'the boost', by
increasing the air flow through the heater. By altering the setting of
the oUTPUT control, the airflow release can be opened and closed
manually, or can be set to open automatically.
Because the manual or automatic opening of the airflow release is
primarily dependent on how much heat remains in the heater, the
amount of charge the heater has taken has a bearing on the time
at which it opens. The boost will not operate and the internal flap
will not open if the output of the heater is already high enough, or if
there is insufficient heat available from the product.
Manual 'BOOST' operation
7
With the oUTPUT control set on minimum (anticlockwise) the
airflow release [boost] remains closed, and heat is released from
the heater only by normal radiation and convection. This alone
may provide sufficient heat on many occasions and therefore no
adjustment of the oUTPUT control is necessary.
8
If a boost of heat is required later in the day, then moving the
oUTPUT control to maximum (clockwise) in the evening will
immediately open the airflow to release more heat.
T
TIP When the next charging period starts the airflow release will
automatically close. If you want to retain the optimum amount of
heat for a boost the next day, ensure you reset the output to
minimum before the start of the next charging period which is
normally overnight.
Automatic 'BOOST' operation
Turning the oUTPUT control to settings beyond
minimum, results in an automatic boost of heat.
9
A high setting on the oUTPUT control i.e. max opens
the airflow release early afternoon/evening.
10
A lower setting as shown opens the airflow later in
the evening.
The most suitable settings of the OUTPUT control for
different conditions will be found by experience.
TIP Remember - a high setting of the OUTPUT control early in the
day may leave too little heat stored in the heater for the evening,
especially during cold weather conditions.
If a boost is not required, e.g. when a room is unoccupied for a long
period, set the OUTPUT control to min (anticlockwise).
Commercial use
11
For commercial use i.e. normal office hours, set the oUTPUT
to maximum (clockwise). Set the INPUT for your particular model
as described on page 3.
Model XL6N, XLS6N
There are no user controls on these models.
1224-XLN/XLSN STORAGE HEATER INSTRUCTIONS.indd 6
6
OUTPUT
control
Output
Output
(Boost closed)
7
Output
(Boost open)
8
Output
(Boost open)
9
Output
(late boost)
10
Output
(Boost open)
11
Input
Input
OUTPUT
setting for
no Boost
Input
OUTPUT
setting for
immediate
Boost
Input
OUTPUT
setting
for earlier
Boost
Input
OUTPUT
setting
for later
Boost
Input
OUTPUT
Commercial
setting
earlier Boost
5
14/01/2011 10:36