Aeon Labs Nano Shutter Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aeon Labs Nano Shutter. Aeon Labs Nano Shutter 10 pages.

Imprimer la page
Configure your Nano Shutters move time going up or down.
You can configure your Nano Shutters time frame moving up or down.
Parameter
#
Sets the move time from up (left) to
35 (0x23)
down (right) for connected motor.
Instant updates.
By default Nano Shutter is not set to report its status automatically. If you need to have your Nano Shutter report to your
gateway any time its status has been changed, you can do so using the configuration settings below:
Parameter
#
To set which report would be sent to
the associated
nodes in association group 1 when
80 (0x50)
the state of output load is changed.
0 = Nothing
1 = Basic Report CC
External Switch control and operation configuration.
You can change how the external switches operate and control Nano Shutters connected motors. This can be set through
a Z-Wave Command Class - Configuration V1 or V2.
Parameter
#
Set the operation mode of external
switch.
85 (0x55)
0 = Operation Mode 1.
1 = Operation Mode 2.
Operation Mode 1. - Split reaction between S1 and S2 controls.
External Switch 1 (S1)
Current State. Stop
Button pressed
Move to
once.
100%
Operation Mode 2. - Same controls over S1 and S2.
Definition
Definition
Definition
Moving to
Moving to
100%
0%
Stop
NC
Move to 0%
External Switch 1 + 2 (S1 and S2
Default
Byte
Value
Size
30
1
Default
Byte
Value
Size
0
1
Default
Byte
Value
Size
0
1
External Switch 2 (S2)
Moving to
Moving to
Stop
0%
Stop
100%
NC