Pioneer A-209 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer A-209. Pioneer A-209 32 pages. Stereo amplifier
Également pour Pioneer A-209 : Catalogue (10 pages), Manuel d'entretien (35 pages)

Imprimer la page

CONNECTING THE SPEAKER CORDS

1. Strip off the vinyl covering and twist the tip of the

wire core.

10mm

Twist the wire core

2. Loosen the knob and insert the wire core into the

terminal hole.

3. Tighten the knob to fix the wire core in place.

NOTE:

Do not allow any of the cord conductors to protrude from the

terminals or touch any other conductors. Malfunctioning or

breakdowns may occur when conductors come into contact

with each other.

Speaker Impedance

[A-209]

When speaker systems are connected to only SPEAKERS A

or SPEAKERS B terminals, such speakers should have rated

impedance in the range of 4–16 Ω.

When speaker are connected to both A and B terminals, they

should have a rated impedance in the range of 8 –32 Ω.

[A-109]

The speaker systems used should have a rated impedance in

the range of 6 - 16 Ω.

CONNECTING THE INPUT/OUTPUT

CORDS

Connect the white plug to the L (left) channel, and the red plug

to the R (right) channel. Be sure to push the plugs securely.

White plug

AC POWER CORD

Plug in the power cord first to the amplifier and then to the

wall outlet after you have finished hooking up the rest of your

equipment.

CAUTION!

• Do not use any other power cord than the one supplied

with this unit.

• The amplifier should be disconnected by removing the

mains plug from the wall socket when not in regular use,

e.g. when on vacation.

Please use the correct cord and plug for your region.

For regions with two pin flat-bladed plug and 200 volts or

greater power supply

For Taiwan exclusively

CONNECTIONS

Left channel

Right channel

Red plug

European two pin plug

with two pin flat-bladed

converter plug (for 200

volts or greater power

supply)

Taiwanese two pin flat-bladed

plug

Make sure the voltage selector

has been switched to the 110 V

position before plugging in the

AC power cord.