Pioneer DCS-370 Manuel d'utilisation - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer DCS-370. Pioneer DCS-370 48 pages. Pioneer dvd receiver operating instructions
Imprimer la page
02
Getting started
Chapter 2
Getting started
Home theater sound setup
Place your speakers as shown below for
optimal surround sound (see the Speaker
Setup Guide for more placement tips).
• Standard surround setup – This is a
standard multichannel surround sound
speaker setup for optimal 5.1 channel
home theater sound.
Front left
Surround
left
After placing your speakers, complete Setting
the channel levels below then refer to Speakers
settings on page 29 to complete your surround
sound setup.
Setting the channel levels
Set the relative channel levels from your main
listening position.
1
Press TEST TONE.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• SR – Right surround speaker
Note
1 • This is only available when DVD/CD is selected and playback is stopped. Also make sure headphones are unplugged.
• To adjust the overall balance while listening to any sound source you want, press SETUP, use / to select CH LEVEL then
press ENTER. Use / to move channel to channel, and / to adjust the channel levels. Press ENTER when you're finished.
2 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
3 The screen saver will appear after five minutes of inactivity.
10
En
Center
Front right
Subwoofer
Listening position
Surround
right
1
• SL – Left surround speaker
2
• SW – Subwoofer
2
Use the VOLUME +/– button to adjust
the volume to an appropriate level.
Use / to adjust the speaker levels in
3
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ±10 dB.
4
When you're done, press ENTER to exit
test tone setup.
Using the on-screen displays
For ease of use, this system makes extensive
use of graphical on-screen displays (OSDs).
All the screens are navigated in basically the
same way, using , , , to change the
highlighted item and pressing ENTER to select
3
it.
Important
• Throughout this manual, 'Select' means
use the cursor buttons to highlight an item
on-screen, then press ENTER.
Button
What it does
HOME
Displays/exits the on-screen display
MENU
Changes the highlighted menu item
ENTER
Selects the highlighted menu item