- ページ 10

レシーバー Pioneer DCS-370のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer DCS-370 48 ページ。 Pioneer dvd receiver operating instructions

ページを印刷する

Getting started

Chapter 2

Getting started

Home theater sound setup

Place your speakers as shown below for

optimal surround sound (see the Speaker

Setup Guide for more placement tips).

• Standard surround setup – This is a

standard multichannel surround sound

speaker setup for optimal 5.1 channel

home theater sound.

Front left

Surround

left

After placing your speakers, complete Setting

the channel levels below then refer to Speakers

settings on page 29 to complete your surround

sound setup.

Setting the channel levels

Set the relative channel levels from your main

listening position.

Press TEST TONE.

The test tone is output in the following order

(from the speakers active in the current

listening mode):

• L – Front left speaker

• C – Center speaker

• R – Front right speaker

• SR – Right surround speaker

Note

1 • This is only available when DVD/CD is selected and playback is stopped. Also make sure headphones are unplugged.

• To adjust the overall balance while listening to any sound source you want, press SETUP, use / to select CH LEVEL then

press ENTER. Use / to move channel to channel, and / to adjust the channel levels. Press ENTER when you're finished.

2 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.

3 The screen saver will appear after five minutes of inactivity.

Center

Front right

Subwoofer

Listening position

Surround

right

• SL – Left surround speaker

• SW – Subwoofer

Use the VOLUME +/– button to adjust

the volume to an appropriate level.

Use / to adjust the speaker levels in

turn.

You should hear the test tone at the same

volume from each speaker when seated in the

main listening position. The channel level

range is ±10 dB.

When you're done, press ENTER to exit

test tone setup.

Using the on-screen displays

For ease of use, this system makes extensive

use of graphical on-screen displays (OSDs).

All the screens are navigated in basically the

same way, using , , ,  to change the

highlighted item and pressing ENTER to select

it.

Important

• Throughout this manual, 'Select' means

use the cursor buttons to highlight an item

on-screen, then press ENTER.

Button

What it does

HOME

Displays/exits the on-screen display

 Changes the highlighted menu item

ENTER

Selects the highlighted menu item