Pioneer Premier PRS-A900 Manuel du propriétaire - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Pioneer Premier PRS-A900. Pioneer Premier PRS-A900 17 pages. Bridgeable four-channel power amplifier
Également pour Pioneer Premier PRS-A900 : Manuel du propriétaire (44 pages), Manuel d'entretien (41 pages)
Imprimer la page
Connecting the Unit
Connecting the Power Terminal
• We recommended that you use the special red
battery and ground wire [RD-228], which is sold
separately. Connect the battery wire directly to
the car battery positive terminal
(+)
and the
ground wire to the car body.
• Recommended wires size (AWG: American Wire
Gauge) is as follows. The battery wire and the
ground wire must be same size.
• Use a lOAWG to 20 AWG wire for the system
remote control wire.
Battery Wire and Ground Wire Size
less than 3.6 m
less than 12 ft.
8AWG
less than 6.4 m
less than 21 ft.
6AWG
2. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
System remote
control terminal
powertemll<~~~nal
_Jt~GND
Battery
~ ~
terminal
~
Ground wire
System remote
control wire
6
WARNING
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive
(+)
terminal of
the battery.
Engine
Interior of
compartment
1\
the vehicle
~-
C1
~U~
[
\
Fuse (40 A
X:Y)
~K
Positive
(+)
Drill a 14
terminal
mm (1/2 in.)
Insert the O-ring rubber grom-
hole into the
met into the vehicle body.
vehicle body.
D
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor bums.
3. Put the wire ties in the slits and
wrap the wire ties around the wires.
• Make sure the wires are connected and
attached properly before wrapping the wire
ties around the wires.
• Wrap the wire tie around the wire insulation,
not the stripped wire.
• Cut off any excess portions of the wire ties.
Wire tie