Dini Argeo ALP Manuel opératoire - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel opératoire pour {nom_de_la_catégorie} Dini Argeo ALP. Dini Argeo ALP 19 pages.

Imprimer la page

5.0 MAINTENANCE

5.1 Troubleshooting

Symptom
Cannot turn on
Poor accuracy
Cannot calibrate
Cannot access mode
Cannot access unit
Err 5
Err 7.0
Err 8.1
Err 8.2
Err 8.3
Err 8.4
Err 9.5
Err 9.8
Error 53
REF Err
LOWREF

5.2 Service Information

If the troubleshooting section does not resolve or describe your problem, contact Dini Argeo Srl
Dini Argeo Srl
Via della Fisica, 20
41042 Spezzano di Fiorano (MO)
Tel. 0536-843418
Fax 0536-843521
Possible Cause
No power to balance
Improper calibration
Unstable environment
Unstable environment
Incorrect calibration masses
Mode not enabled
Units not enabled
Average Piece Weight too small
Time out
Pan has load during power on
Pan was removed prior to power on Install pan and re-zero.
Weight on pan exceeds capacity
Pan was removed during weighing
Factory calibration data corrupted
Factory calibration data corrupted
EEPROM Checksum error
Reference Weight is too small
Reference Weight is too low for
accurate parts counting or percent
weighing.
Remedy
Verify connections and voltage.
Perform calibration
Move balance to suitable location
Move the balance to suitable location
Use correct calibration masses
Enter menu and enable mode
Enter menu and enable units
Add additional samples
Remove weight from pan and re-zero.
Remove weight from the pan
Re-install pan
Contact the authorized dealer
Perform calibration
Contact the authorized dealer
Add additional samples
Add additional samples or continue to
weigh with less accurate results.
15