Aeotec ZWA039 Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Aeotec ZWA039. Aeotec ZWA039 12 pages. Temperature & humidity sensor

Imprimer la page

respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action

right on the device.

Inclusion

1. Insert the battery.

2. Press the button quickly three times in a row.

Exclusion

1. Press the button quickly three times in a row.

Product Usage

Once the device is powered up it will start monitoring the air parameters and warn of mould using the

local red and green LED. Pushing the button will force an immediate measurement and the LEDs will

indicate the danger of mould.

green: no danger of mould in the room



red: danger of mould, open the windows to lower the humidity



The device contains two sensors with the following accuracy measures:

Relative Humidity: precision ± 3% RH (max), range 0 to 80% RH



Temperature: precision ±0.8 °C (max), range -10 to 65 °C



Dew Point: precision ±0.8 °C (max), range -10 to 65 °C (calculated from other sensor values)



The device sends the following notifications to the central controller:

Weather Alarm - Moisture Alarm (0x10 - 0x02)



Power management - Replace battery now (0x08 - 0x0b)



Heat Alarm - Overheat Unknown Location (0x04 - 0x02)



Heat Alarm - Underheat Unknown Location (0x04 - 0x06)



For getting the status of the device on the network you need insert a battery to device. And you see

result: - "The GREEN LED will blink one time in case of success or RED LED will blink five times in case of

failure".

Quick trouble shooting

Here are a few hints for network installation if things don't work as expected.

1. Make sure a device is in factory reset state before including. In doubt exclude before include.

2. If inclusion still fails, check if both devices use the same frequency.

3. Remove all dead devices from associations. Otherwise you will see severe delays.

4. Never use sleeping battery devices without a central controller.

5. Don

t poll FLIRS devices.

6. Make sure to have enough mains powered device to benefit from the meshing