Cal Flame BBQ09843B Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Cal Flame BBQ09843B. Cal Flame BBQ09843B 13 pages. Beer keg refrigerator

Imprimer la page

Cal Flame BBQ09843B Manuel d'instruction

INSTALLING THE

Follow these steps to safely

install the

regulator and

cylinder. You must read

and understand the following

procedures for the

before installation.

NOTE: Your

cylinder

has DOT (USA Department

of Transportation) approval,

however the cylinder has

been shipped empty to avoid

any possible accidents during

transportation. When you

purchase the ﬁrst keg of beer,

you must also have your

cylinder ﬁlled at your local

supplier. (See page 2, item 9 for

suggested locations within your

community.)

1. Install the

gas line tube to the regulator by attaching one end of the tube to the hose barb

connection on the

2. Insert the special washer (provided with the kit) into the regulator to cylinder attachment nut. (See

Illustration A, on page 6)

3. Attach the

regulator to the

tightening with an adjustable wrench.

4. Wrap the rubber strap that is attached to the interior of beer keg fridge unit around the

secure the bottle in place (as shown above).

5. Position the cylinder so that you would be able to read the numbers on the gauges and have easy

access to shut-off valves.

DANGER!

can be dangerous!

improperly. They must be handled with care.

TAPPING THE BEER KEG – INSTALLING KEG TAP

(SINGLE-VALVE TYPE BARREL)

Follow these steps below to tap the beer keg.

1. Make sure the black pull handle of the tap is in the closed (up) position before installing it on the keg

(Fig. 1 - below). Insert the keg coupler into the locking neck of the beer keg and turn clockwise ¼ to lock

it into position (Fig. 2 - below). This means that it is secured to the keg.

2. When connecting the beer line, it is very important that the black rubber washer be installed inside the

wing nut before connecting the beer line to the tap ( See Illustration A below). Remove the black rubber

protective cap located on top of tap and screw the Wing nut with the rubber washer. Tighten it ﬁrmly by

hand. (Fig.2-below)

REGULATOR AND THE CO2 CYLINDER

cylinders

regulator. (See Illustration B, on page 6)

cylinder by screwing the regulator nut onto the cylinder valve and

cylinders contain high-pressured gas, which can be hazardous if handled

bottle to

Page.