Ariston PH 760 RF GH Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ariston PH 760 RF GH. Ariston PH 760 RF GH 11 pages. Ariston hob

Imprimer la page

back panel of the cooker could reach a temperature of

50°C above room temperature. For proper installation of

the cooker, the following precautions must be taken:

a) The hob may be located in a kitchen, a kitonen/diner

or bed sitting room, but not in a bathroom or shower

room.

b) The furniture standing next to the unit, that is higher

than the working boards, must be placed at least 600

mm from the edge of the board.

c) The cabinets should be positioned next to the hood at

a height of at least 420 mm (Fig. C).

600mm min.

d) Should the hob be installed directly under a cupboard,

the letter should be at least 700mm (millimetres) from

the worktop, as shown in Fig. C.

e) The dimensions of the room for the furniture must be

those indicated in the figures in the last two pages of

the cover. Fixing hooks are provided which allow to

place the hob plate on work tops that measure from

20 to 40 mm in thickness (see Fig. D). To obtain a good

fixing of the hob plate it is advisable to use all the hooks

supplied.

Hook position for

H=30mm top

Fig. C

555

Fig. D

Hook position for

H=40mm top

Hook position for

H=20mm top

N.B: Use the hook contained in the "accessoires set"

f) The hob can only be installed above built-in ovens

provided with cooling ventilation.

g) In the event the cooktop is not installed above a built-

in oven, a wood panel must be inserted as insulation.

This panel must be placed at least 20 mm from the

bottom of the cooktop itself.

Important: When installing the hob above a built-in oven,

the oven should be placed on two wooden strips; in the

case of a joining cabinet surface, remember to leave a

space of at least 45 x 560 mm at the back.

Gas connection for gas hob

The cooker should be connected to the gas-supply by a

corgi registered installer. During installation of this product

it is essential to fit an approved gas tap to isolate the supply

from the appliance for the convenience of any subsequent

removal or servicing. Connection of the appliance to the

gas mains or liquid gas must be carried out according to

the prescribed regulation in force, and only after it is

ascertained that it is adaptable to the type of gas to be

used. If not, follow the instructions indicated in the

paragraph headed "Adaptation to different gas types". In

the case of connection to liquid gas, by tank, use pressure

regulators that conform to the regulation in force.

Important: For safety, for the correct regulation of gas

use and long life of the appliance, ensure that the gas

pressure conforms to the indications given in table 1

"Nozzle and burner characteristics".

Connection to non-flexible tube

(copper or steel)

Connection to the gas source must be done in such a

way as to not create any stress points at any part of the

appliance.

The appliance is fitted with an adjustable, "L" shaped

connector and a gasket for the attachment to the gas supply.

Should this connector have to be turned, the gasket must be

Front

Back