Whirlpool EL88TRRWS Manuel d'instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Whirlpool EL88TRRWS. Whirlpool EL88TRRWS 20 pages. Trim kit
Également pour Whirlpool EL88TRRWS : Manuel des dimensions (1 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien du réfrigérateur (28 pages), Manuel de l'énergie (2 pages)

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Before you move your refrigerator and freezer into their final

location, it is important to make sure you have the proper

electrical connection.

Recommended grounding method

A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your refrigerator and a separate circuit serving

only your freezer be provided. Use an outlet that cannot be

turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the Temperature Control to the OFF

position as shown and then disconnect the refrigerator from the

electrical source.

1. Assemble the six grille extrusions by sliding one into the other

through the tongue and groove feature as shown.

2. Attach the notched grille extrusion to those already

assembled by sliding it into the bottom/lowest grille.

3. Install the top trim extrusion onto the grille assembly by

sliding it onto the grille extrusion at the top.

1. Align the side trim extrusions with the sides of the grille

assembly.

NOTE: Make sure all the grille extrusions are contained within

the channel of the side extrusions and the top surface of the

top trim extrusion is flush with the top surface of the sides.

2. Align the hole on the side extrusion with the groove on the

top extrusion on each side of the grille assembly. There will

be a

" (9.5 mm) gap between extrusions.

3. Using the two countersunk Phillips screws, fasten the side

trim to the grille assembly. Insert the screw through the

predrilled hole and into the groove on each side of the grille

assembly as shown.

(9.5 mm)