Whirlpool EL88TRRWS 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} Whirlpool EL88TRRWS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool EL88TRRWS 20 페이지. Trim kit
Whirlpool EL88TRRWS에 대해서도 마찬가지입니다: 치수 매뉴얼 (1 페이지), 사용 및 관리 매뉴얼 (24 페이지), 냉장고 사용 및 관리 매뉴얼 (28 페이지), 에너지 매뉴얼 (2 페이지)
페이지 인쇄
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator and freezer into their final
location, it is important to make sure you have the proper
electrical connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator and a separate circuit serving
only your freezer be provided. Use an outlet that cannot be
turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the Temperature Control to the OFF
position as shown and then disconnect the refrigerator from the
electrical source.
ASSEMBLY INSTRUCTIONS
Assemble the Top Grille
1. Assemble the six grille extrusions by sliding one into the other
through the tongue and groove feature as shown.
4
2. Attach the notched grille extrusion to those already
assembled by sliding it into the bottom/lowest grille.
3. Install the top trim extrusion onto the grille assembly by
sliding it onto the grille extrusion at the top.
Attach the Side Trim Extrusions
1. Align the side trim extrusions with the sides of the grille
assembly.
NOTE: Make sure all the grille extrusions are contained within
the channel of the side extrusions and the top surface of the
top trim extrusion is flush with the top surface of the sides.
2. Align the hole on the side extrusion with the groove on the
top extrusion on each side of the grille assembly. There will
be a
" (9.5 mm) gap between extrusions.
3. Using the two countersunk Phillips screws, fasten the side
trim to the grille assembly. Insert the screw through the
predrilled hole and into the groove on each side of the grille
assembly as shown.
"
(9.5 mm)