Whirlpool EL88TRRWS 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Whirlpool EL88TRRWS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool EL88TRRWS 20 페이지. Trim kit
Whirlpool EL88TRRWS에 대해서도 마찬가지입니다: 치수 매뉴얼 (1 페이지), 사용 및 관리 매뉴얼 (24 페이지), 냉장고 사용 및 관리 매뉴얼 (28 페이지), 에너지 매뉴얼 (2 페이지)

페이지 인쇄

1. Opening Requirements

Install the Top Grille and Trim Assembly

IMPORTANT: The top grille and trim assembly, and your floor can

be damaged if the assembly is dropped.

Prepare the Opening

1. Place cardboard or hardboard over the floor at each side of

the rough opening where the side trim will meet the floor.

2. Place the top grille and trim assembly face down on the floor

centered in front of the rough opening.

3. Using two people, one on each side, lift the trim assembly

and position it into place above and on each side of the

opening.

4. Use several pieces of tape to temporarily hold the assembly

in place as shown.

5. Mark the trim assembly hole locations around the opening.

Remove the tape and lower the trim assembly back to the

floor.

6. Using a cordless drill and

where marked.

NOTE: Some cabinetry or wall materials may require

predrilled holes using a

7. Repeat steps 3 and 4.

Fasten the Top Trim to the Opening

Align the top extrusion against the opening, so that it is tight

and flush with the front surface of the wall opening or

cabinetry.

2. From below and behind the top trim extrusion, insert a pan

head Phillips screw through the predrilled center hole of the

top trim and into the wall opening or cabinetry.

NOTE: Do not completely tighten the screw.

INSTALLATION INSTRUCTIONS

" diameter drill bit, drill holes

" diameter drill bit.

3. Using a carpenter's level, level the top trim, and shim as

necessary.

NOTE: Shims are not provided with the trim kit.

4. Using two pan head Phillips screws, fasten the top trim

extrusion by inserting a screw through the predrilled holes at

each end. Completely tighten the screws.

5. Completely tighten the center screw.

Fasten the Side Trim to the Opening

1. Using a carpenters level, make sure the sides are plumb, and

shim as necessary.

NOTE: Shims are not provided with the trim kit.

2. Using four pan head Phillips screws (two on each side),

fasten both the left-hand and right-hand side trim extrusions

to the opening or cabinetry. Make sure the trim does not

twist.

Place and Align Refrigerator and Freezer

WARNING

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

When Moving Your Freezer or Refrigerator:

Your freezer and refrigerator are heavy. When moving the

appliance for cleaning or service, be sure to cover the floor

with cardboard or hardboard to avoid floor damage. Always

pull the appliance straight out when moving it. Do not wiggle

or "walk" the appliance when trying to move it, as floor

damage could occur.