Whirlpool 240-VOLT ELECTRIC DRYER Manuel d'utilisation et d'entretien - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool 240-VOLT ELECTRIC DRYER. Whirlpool 240-VOLT ELECTRIC DRYER 33 pages. 240-volt electric dryer
Également pour Whirlpool 240-VOLT ELECTRIC DRYER : Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (32 pages)

INSTALLATION INSTRUCTIONS

1. Disconnect power.

2. Remove hold-down screw and terminal

block cover.

3. Attach a

⁄

-inch, U.L.-listed, strain relief to

the hole below terminal block opening.

Strain relief should have a tight fit with

dryer cabinet and be in a horizontal

position. Put the power supply cord

through the strain relief.

4. Loosen or remove terminal block screws.

Connect the neutral wire (white or center)

of power supply cord under the center

screw of the terminal block.

5. Connect the other two wires to outer

terminal block screws. Tighten all terminal

block screws firmly.

6. Tighten the strain relief screws.

7. Insert tab of terminal block cover into slot

of the dryer rear panel. Secure cover with

hold-down screw.

NOTE: If local codes do not permit the

connection of a frame-grounding conductor

to the neutral wire, see the instructions for

"Alternate Connection" later in this section.

Terminal block cover

External ground

Center silver-colored

connector

terminal block screw

Neutral ground-

ing wire

(green/yellow)

3-Wire Connection with

Frame-Grounding Conductor

Hold-down screw

Neutral

wire

(white)

⁄

", U.L.-listed,

strain relief