Whirlpool CGW9100VQ0 Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Whirlpool CGW9100VQ0. Whirlpool CGW9100VQ0 40 pages. Commercial dryer- gas or electric

Imprimer la page

Power supply cord strain relief:

[]

Remove the screws from a 3/4"(1.9 cm)

UL listed strain relief (UL marking on strain

relief). Put the tabs of the two clamp

sections into the hole below the terminal

block opening so that one tab is pointing

up and the other is pointing down, and

hold in place.

[]

Put power supply cord through the strain

relief. Be sure that the wire insulation on

the power supply cord is inside the strain

relief. The strain relief should have a tight

fit with the dryer cabinet and be in a

horizontal position. Do not further tighten

strain relief screws at this point.

Tighten strain relief screws enough to hold the

two clamp sections together.

A. Strain relief tab

pointing up

B. Hole below terminal

block opening

C. Clamp section

D. Strain relief tab

pointing down

Now complete installation following

instructions for your type of electrical

connection:

4-wire (recommended)

3-wire (if 4-wire is not available)