Whirlpool CGW9100VQ0 설치 매뉴얼 - 페이지 14

{카테고리_이름} Whirlpool CGW9100VQ0에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CGW9100VQ0 40 페이지. Commercial dryer- gas or electric

Power supply cord strain relief:

[]

Remove the screws from a 3/4"(1.9 cm)

UL listed strain relief (UL marking on strain

relief). Put the tabs of the two clamp

sections into the hole below the terminal

block opening so that one tab is pointing

up and the other is pointing down, and

hold in place.

[]

Put power supply cord through the strain

relief. Be sure that the wire insulation on

the power supply cord is inside the strain

relief. The strain relief should have a tight

fit with the dryer cabinet and be in a

horizontal position. Do not further tighten

strain relief screws at this point.

Tighten strain relief screws enough to hold the

two clamp sections together.

A. Strain relief tab

pointing up

B. Hole below terminal

block opening

C. Clamp section

D. Strain relief tab

pointing down

Now complete installation following

instructions for your type of electrical

connection:

4-wire (recommended)

3-wire (if 4-wire is not available)