FirePro FPC-2 Manuel d'utilisation et d'entretien - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} FirePro FPC-2. FirePro FPC-2 7 pages. Fire control panel system isolation
Également pour FirePro FPC-2 : Manuel d'utilisation et d'installation (14 pages), Manuel d'utilisation et d'entretien (8 pages), Manuel de démarrage rapide (2 pages)

Connection of Aerosol Units to Activation circuit

These terminals are for the connection of FirePro®

Aerosol Generators. Test lamps are provided in the

terminals to allow testing of the system before

connecting the FirePro® generators. These test lamps

should be removed from the terminals if a FirePro®

Aerosol Generator is to be fitted.

Any FirePro® generator outputs that are not being

used should be left with test lamps fitted.

When constructing leads to the FirePro units the supplied Deutsch Plugs must be used to ensure water-proof

connections are made throughout the installation.

1. Cut cable to required length and strip outer insulation to approximately 50mm.

2. Strip inner insulation to approx. 6mm and using a Deutsch Crimping tool, fix pins to the exposed ends of

the cable, including the earth.

3. Place heat shrink or rubber boot over the end of the cable. Identify correct

socket on plug by the numbers/letter on the side of the plug and push through

the gasket at the bottom of the plug until a click is heard and the pin is locked

in place.

4. Place the locking wedge inside the plug to ensure pins remain secure. (Male

plugs the locking wedge is orange. Female plugs the locking wedge is green)

5. Using the heat shrink and rubber boot, seal the back of the plug.

Power Indicator

Operates as long as voltage is coming into panel – range is 6-30vDC.

Fault Indicator

Operates whenever any circuit fault is detected in the system. It is a common indictor for

both the activation and detection circuits.

Fire Indicator

Operates when the detection circuit goes into alarm.

The Fault Relay is normally energised and will de-energise upon any fault condition on the detection part or the

extinguishant part of the control panel including total loss of power. Volt free changeover contact that will

operate whenever there is a fault condition. This contact is rated for a maximum of 30V DC and

1Amp. These ratings must not be exceeded

The Fire Relay will energise upon activation of a fire condition. The relay will remain activated until the control

panel is reset. Volt free changeover contact that will operate whenever the system is triggered to alarm. This

contact is rated for a maximum of 30V DC and 1Amp. These ratings must not be exceeded.

fp_c2_m5.3

Page 5 of 7