Alcolock V3 Manuel d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Alcolock V3. Alcolock V3 8 pages. Series b-2, 12v & 24v ecu

UNINSTALLATING THE ECU

To be done only when removing the ECU from the vehicle.

Disconnect all wires that come from the ECU wiring harness and are connected to different

parts of the vehicle electrical system. Unsolder all connections and tape the wires.

Disconnect the terminal ring (which is connected to the black ground wire in the wiring

harness) from the ground point on the vehicle (the connection was made with a metal crimp

ring and nut).

Locate the wire that was cut during installation. This wire was part of the vehicle's main

harness and it ran between the ignition switch and the starter relay or solenoid. Reconnect

the wire.

Once the ECU is uninstalled (the above 3 steps), attempt to start the vehicle engine by

turning the ignition switch.

DISPOSAL AT END OF SERVICE LIFE

To dispose of the ALCOLOCK V3 device (ECU, handset, or both) when it is deemed to be at the

end of its service life:

• Return the device to the dealer for disposal

• Contact the local waste management authority for more information

• Ask a suitable disposal contractor to dispose of the device

WIRING TABLE

COLOUR

Red

Black

White

Blue (2 wires)

Blue / Yellow (2)

Green

Yellow / Red

Blue / White

Pink

Brown

LOCATION

+12 or +24 volts, un-switched, fused 10A

Ground

Ignition switch

To starter

From ignition switch

Engine run signal

CAN bus 1

CAN bus 2

Wake up signal (connected to vehicle parking lamps)

(+) AUX lamp

REQUIRED

Yes

Optional

ALCOLOCK V3 SERIES B-2