Xerox Phaser 6100DN Manuel de démarrage - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Xerox Phaser 6100DN. Xerox Phaser 6100DN 37 pages. Disk overwrite installation and usage
Également pour Xerox Phaser 6100DN : Manuel d'installation (34 pages), Spécifications (2 pages), Manuel de l'utilisateur (32 pages), Brochure & Specs (4 pages), Manuel de l'utilisateur (28 pages), Manuel d'installation (2 pages), Manuel de sécurité (38 pages), Manuel d'installation (2 pages), Note de mise à jour (2 pages), Manuel (34 pages), Manuel (34 pages), Manuel de démarrage (34 pages), Manuel de l'utilisateur (32 pages), Manuel d'installation et d'utilisation (8 pages)

Imprimer la page

DOCUSP 4.1

TGBackup

TGBackup is an interim tape backup tool that supplements the

DocuSP System Backup utility. Backing up to tape in not yet

available in the Backup and Restore feature in DocuSP.

TGBackup provides the ability to backup the system files to a

tape.

TGBackup is installed on the DocuSP by the Xerox service

representative. The TGBackup utility consists of the following

files:

♦

TGBackup.htm – these directions in html format.

♦

start_tgbackup – the TGBackup launch script

♦

run_tgbackup – the script used to invoke backup on a reboot

of the DocuSP

♦

tgbackup – the backup utility

♦

tg_checkswap – a script to check for and recreate the swap

space

♦

start_tgrestore – the recovery launch script

♦

tgrestore – the recovery utility

Performing a backup

To perform a backup perform the following steps:

Insert the TGBackup CD.

Ensure the tape drive is connected and powered on. Insert

a blank write-enabled tape cassette. If multiple tape drives

are on the system, make sure that only the drive you wish

to use is ready or online. TGBackup will use the first ready

tape drive it finds.

Open a terminal window and logon as root user.

Enter the command cd /cdrom/cdrom0/TGBackup to

change to the TGBackup directory.

Enter the command sh start_tgbackup to start the backup

process; the script initiates a file system check then power

the printer off.

Power the printer back on. TGBackup interrupts the boot

process, locates the tape drive and starts the backup to

tape. Once every ten minutes the screen updates with the

percentage of the job completed and an estimate of how

much more time is required to finish dumping the current

file system. A typical system being dumped to 4mm tape

takes an average of 2 hours.

XEROX DOCUMENT SERVICES PLATFORM SERIES

GETTING STARTED