Xerox Phaser 6100DN Manuel de démarrage - Page 31

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Xerox Phaser 6100DN. Xerox Phaser 6100DN 37 pages. Disk overwrite installation and usage
Également pour Xerox Phaser 6100DN : Manuel d'installation (34 pages), Spécifications (2 pages), Manuel de l'utilisateur (32 pages), Brochure & Specs (4 pages), Manuel de l'utilisateur (28 pages), Manuel d'installation (2 pages), Manuel de sécurité (38 pages), Manuel d'installation (2 pages), Note de mise à jour (2 pages), Manuel (34 pages), Manuel (34 pages), Manuel de démarrage (34 pages), Manuel de l'utilisateur (32 pages), Manuel d'installation et d'utilisation (8 pages)

Nuvera Stacker/Finisher Script

XEROX DOCUMENT SERVICES PLATFORM SERIES

GETTING STARTED

For the Nuvera family of printers, you must use the following

script to set up Stackers and/or Finishers:

1. Open a terminal window.

2. Login as root.

3. Type cd /opt/XRXnps/bin/DFA_IsStacker.

4. Press <Enter>.

5. Type ./set –f 0 OR ./set –f 1. Use the value 0 if the

attached DFA device is a finisher, or use the value of 1 if

the attached DFA device is a stacker. Note that there are

spaces before and after the –f switch.

6. Restart DocuSP.

NOTE: This setting is lost on an upgrade or a scrape

install and must be recreated using this procedure.

Prior to DocuSP 4.0, the controller applied the LPR gateway

filename to submitted documents as opposed to the internally

set document name. Starting with DocuSP 4.0, the controller

applies the internal document name to the job.

To set the DocuSP to the pre-4.0 behavior, run the following

script:

1. Open a terminal window.

2. Login as root.

3. Type enablePre40LPRBehavior

4. Press <Enter>.

5. To disable the pre-4.0 LPR behavior, type

disablePre40LPRBehavior

6. Restart DocuSP.

NOTE: A document name set in the job ticket has a higher

precedence than the LPR gateway and internal document

attributes.

DOCUSP 4.1