Xerox Phaser 6100DN Başlangıç Kılavuzu - Sayfa 31

Yazdırma Sunucusu Xerox Phaser 6100DN için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Xerox Phaser 6100DN 37 sayfaları. Disk overwrite installation and usage
Ayrıca Xerox Phaser 6100DN için: Kurulum Kılavuzu (34 sayfalar), Teknik Özellikler (2 sayfalar), Kullanıcı Kılavuzu (32 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Kullanıcı Kılavuzu (28 sayfalar), Kurulum Kılavuzu (2 sayfalar), Güvenlik Kılavuzu (38 sayfalar), Kurulum Kılavuzu (2 sayfalar), Yayın Notu (2 sayfalar), Manuel (34 sayfalar), Manuel (34 sayfalar), Başlangıç Kılavuzu (34 sayfalar), Kullanıcı Kılavuzu (32 sayfalar), Kurulum ve Kullanım Kılavuzu (8 sayfalar)

Nuvera Stacker/Finisher Script

XEROX DOCUMENT SERVICES PLATFORM SERIES

GETTING STARTED

For the Nuvera family of printers, you must use the following

script to set up Stackers and/or Finishers:

1. Open a terminal window.

2. Login as root.

3. Type cd /opt/XRXnps/bin/DFA_IsStacker.

4. Press <Enter>.

5. Type ./set –f 0 OR ./set –f 1. Use the value 0 if the

attached DFA device is a finisher, or use the value of 1 if

the attached DFA device is a stacker. Note that there are

spaces before and after the –f switch.

6. Restart DocuSP.

NOTE: This setting is lost on an upgrade or a scrape

install and must be recreated using this procedure.

Prior to DocuSP 4.0, the controller applied the LPR gateway

filename to submitted documents as opposed to the internally

set document name. Starting with DocuSP 4.0, the controller

applies the internal document name to the job.

To set the DocuSP to the pre-4.0 behavior, run the following

script:

1. Open a terminal window.

2. Login as root.

3. Type enablePre40LPRBehavior

4. Press <Enter>.

5. To disable the pre-4.0 LPR behavior, type

disablePre40LPRBehavior

6. Restart DocuSP.

NOTE: A document name set in the job ticket has a higher

precedence than the LPR gateway and internal document

attributes.

DOCUSP 4.1