3
IN NORMAL MODE
MAX
IN SHIFT MODE
NORMAL MODE PRESETS
SHIFT MODE PRESETS
101 ~ 424
101 ~ 424
INTERNAL RAM 1 ~ 24 {
| INTERNAL ВАМ 1 ~ 24
MIN
DATA
ENTRY
The BANK memories are not actually loaded with the voice data, but the voice
number. Thus, when
a BANK memory location is selected, the voice corre-
sponding to the voice number stored in that location is called from its memory
in either the INTERNAL or PRESET memories.
9: CASSETTE SAVEIVERIFY
SAVE/VERIFY
CASSETTE
This function actually has two "sub-functions": SAVE and VERIFY. After calling
this function, subsequent presses of button #9 alternates between the SAVE and
VERIFY sub-functions.
Normally, however, you will start with the SAVE function,
which saves the entire contents of the DX27/27S's INTERNAL voice memory onto
cassette tape. The VERIFY function is then used to compare the data saved on
cassette with the data still in INTERNAL memory, to make sure that no errors occured
in the SAVE process.
Before using this function, make sure that an appropriate data cassette recorder
is properly connected to the DX27/27S, as described in CHAPTER I: SETTING
UP.
When this function is initially called, the LCD will read "Save to Tape ?" Confirm
your intention to save the contents of the 24 voices to cassette tape by pressing
the +1 button. The display will then read "Save ready?" At this point, make sure
that the cassette recorder is set up properly with a suitable blank tape, and then
set up the recorder to begin recording. To perform the actual save operation, press
the +1 button.
(Pressing the -1 button prior to the final step in the above process
will abort the CASSETTE SAVE function.) As the DX27/27S saves each voice to
tape, the LCD display will indicate the voice number being saved.
When all 24 voices have been saved, the DX27/27S will automatically go into the
VERIFY mode, so that you can make sure that the data was recorded properly.
Stop the cassette recorder. The LCD will now read "Verify Tape ?" To verify, first
rewind the tape to the beginning of the data just saved, and then press the +1
button in response to the "Verify Tape ?" display showing. The display will now
read "Verify ready?" Press the +1 button to confirm and then start the cassette
recorder (playing). The DX27/27S will now read in each voice from the cassette
tape, and compare it with the corresponding voice data in the INTERNAL voice
memory, while the LCD indicates the verification process. If the cassette and IN-
TERNAL data matches, the display will read "Verify Completed." You can then enter
any of the PLAY modes by simply pressing the corresponding mode selector button.
If an error is encountered, this will be displayed on the LCD.
If this happens, go
back and try the SAVE process—followed by the VERIFY process—one more time.
If the error persists, then you may have to carefully adjust the record and/or playback
level of the cassette recorder, or use a higher quality recorder or tape. Be sure to
check that all cassette connections are set up properly.
Ware
rp
359373
Imprimer la page