Yamaha IPA8200 Manuel du propriétaire - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha IPA8200. Yamaha IPA8200 19 pages. Yamaha power amplifier owner's manual

Imprimer la page

Controls and Functions

Front Panel

q POWER switch and indicator

Turns power to the unit on or off. The indicator lights green

when the power is on.

w PROTECT indicator

When the protection system is active, the indicator lights

red. When this is lit, the ampliﬁer or power supply is auto-

matically shut down, and no sound will be output from the

speakers.

e CLIP indicator

This indicator will light red when the output power exceeds

100 W for an 8Ω load or 200 W for a 4Ω load. When this is

lit, the limiter will automatically operate.

r SIGNAL indicator

This indicator will light green when the output level exceeds

2 Vrms. (This will light at 0.5 W or greater for an 8Ω load,

1W or greater for a 4Ω load.)

t Attenuator

These are detented knobs that attenuate the input signal of

each channel (A–H) over 41 steps in a range of 0 dB – –∞

dB.

• To operate these knobs, use a slotted screwdriver with

NOTE

a blade no wider than 5.5 mm.

Security cover

y MUTE indicator

This will light red when mute is activated.

u MUTE switch

This turns muting on/off for each channel. Use a thin rod to

turn muting on/off.

i PARALLEL indicator

This will light orange when the rear panel MODE switch is

set to PARALLEL.

o BRIDGE indicator

This will light orange when the rear panel MODE switch is

set to BRIDGE.

!0 Screw holes for security cover

If desired, you can use these two screw holes for attaching

the included security cover to prevent the attenuator setting

from being changed. Use the included Allen wrench and

screws to attach the cover.

!1 Air intakes

The ampliﬁer uses forced-air cooling. The variable speed

cooling fan draws air in from the front and exhausts it

through the rear. The cooling fan operates at low speed when

the heat sink temperature is below 65 °C (149 °F), or at high

speed when the temperature exceeds 65 °C (140 °F). Please

be sure that you do not block the air intakes or exhaust vents.

IPA8200 Owner's Manual