Yamaha DSP-E390 Manuel du propriétaire - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Yamaha DSP-E390. Yamaha DSP-E390 16 pages. Natural sound digital sound field processor
- 1. Table of Contents
- 2. Safety Instructions
- 3. Supplied Accessories
- 4. Profile of this Unit
- 5. Speaker Setup
- 6. Integrated Amplifier or Stereo Receiver
- 7. Connections
- 8. Connecting Speakers
- 9. Identification of Controls
- 10. Speaker Balance Adjustment
- 11. Using Digital Sound Field Processor (DSP)
- 12. Notes about the Remote Control Transmitter
- 13. Troubleshooting
- 14. Specifications
SPEAKERS TO BE USED
This unit is designed to provide the best sound-field quality with a 5 speaker configuration. The most effective speakers to use with
this unit are front speakers, rear speakers and a center speaker. You may omit the center speaker. (Refer to the "4-Speaker
Configuration" shown below.)
The front speakers are used for the main source sound plus the effect sounds. They will probably be the speakers from your
present stereo system. The rear speakers are used for the effect and surround sounds, and the center speaker is for the center
sounds (dialog etc.) within the Dolby Surround encoded programs. The center speaker needs to be equal in power to the front
speakers, although the rear speakers should not be equal. However, all the speakers should have high enough power handling to
accept the maximum output of this unit.
SPEAKER CONFIGURATION
5-Speaker Configuration
This configuration is the most effective and recommended one.
In this configuration, the center speaker is necessary as well as
the rear speakers. If the digital sound field program DOLBY
PRO LOGIC or DOLBY PRO LOGIC ENHANCED is selected,
conversations will be output from the center speaker and the
ambience will be excellent.
Set the center channel mode to the "NORMAL" or "WIDE"
position. (For details, refer to page 10.)
Front L
Surround sound
Surround sound
Rear L
SPEAKER PLACEMENT
The recommended speaker configuration, the 5-speaker configuration, will require two speaker pairs: front speakers (your normal
stereo speakers), and rear speakers, plus a center speaker. When you place these speakers, refer to the following.
Front R
Center
Front L
TV set
SPEAKER SETUP
Center
Front R
Dialogue
Dialogue
Rear R
Rear R
Rear L
4-Speaker Configuration
The center speaker is not used in this configuration. If the
digital sound field program DOLBY PRO LOGIC or DOLBY
PRO LOGIC ENHANCED is selected, the center sound is
output from the left and the right front speakers. However, the
sound effect of other programs can be the same as that of the
5-speaker configuration.
Be sure to set the center channel mode to the "PHANTOM"
position. (For details, refer to page 10.)
Front L
Dialogue
Dialogue
Surround sound
Surround sound
Rear L
Front:
In normal position. (The position of your present
stereo speaker system.)
Rear:
Behind your listening position, facing slightly inward.
Nearly six feet (approx. 1.8 m) up from the floor.
Center: Precisely between the front speakers. (To avoid
interference with TV sets, use a magnetically shielded
speaker.)
Front R
Rear R
5