Clark Synthesis TACTILE SOUND AQ339 Aquasonic Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 20 pages. Underwater speaker
Également pour Clark Synthesis TACTILE SOUND AQ339 Aquasonic : Manuel complémentaire (4 pages), Spécifications (1 pages), Liste des pièces (1 pages), Manuel de l'utilisateur (1 pages), Fiche de référence (1 pages), Manuel d'installation (12 pages), Manuel d'installation (3 pages), Spécifications (1 pages)

IN-WALL INSTALLATION

Place the wire clamp under each clamp tab, verifying the nut and bolt adjuster is accessible when

the clamp is placed under the tabs. Insure the mounting gasket and face ring are still evenly

centered. Use a wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened,

the wire clamp should be firmly seated in each clamp tab and the speaker should be secure. Pick

up the assembly and insure it is still properly centered in the face ring. If not, loosen the wire

clamp and adjust.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche. For

future speaker servicing, leave enough speaker wire in the niche to allow the speaker to be placed

on the pool deck.

Note: In actual applications, the niche will already be mounted in the wall of the pool.

Diluvio

Underwater Speaker

™