Clark Synthesis TACTILE SOUND AQ339 Aquasonic Installatiehandleiding - Pagina 10

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 20 pagina's. Underwater speaker
Ook voor Clark Synthesis TACTILE SOUND AQ339 Aquasonic: Aanvullende handleiding (4 pagina's), Specificaties (1 pagina's), Onderdelenlijst (1 pagina's), Gebruikershandleiding (1 pagina's), Referentieblad (1 pagina's), Installatiehandleiding (12 pagina's), Installatiehandleiding (3 pagina's), Specificatie (1 pagina's)

IN-WALL INSTALLATION

Place the wire clamp under each clamp tab, verifying the nut and bolt adjuster is accessible when

the clamp is placed under the tabs. Insure the mounting gasket and face ring are still evenly

centered. Use a wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened,

the wire clamp should be firmly seated in each clamp tab and the speaker should be secure. Pick

up the assembly and insure it is still properly centered in the face ring. If not, loosen the wire

clamp and adjust.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche. For

future speaker servicing, leave enough speaker wire in the niche to allow the speaker to be placed

on the pool deck.

Note: In actual applications, the niche will already be mounted in the wall of the pool.

Diluvio

Underwater Speaker

™