Clark Synthesis TACTILE SOUND AQ339 Aquasonic Installatiehandleiding - Pagina 9

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 20 pagina's. Underwater speaker
Ook voor Clark Synthesis TACTILE SOUND AQ339 Aquasonic: Aanvullende handleiding (4 pagina's), Specificaties (1 pagina's), Onderdelenlijst (1 pagina's), Gebruikershandleiding (1 pagina's), Referentieblad (1 pagina's), Installatiehandleiding (12 pagina's), Installatiehandleiding (3 pagina's), Specificatie (1 pagina's)

Loosen the nut on the wire clamp. With the mounting gasket facing up, place the wire clamp over

the speaker. The screw & nut should be facing down towards the speaker not the sound lens.

Nut

Wire Clamp

NOTE: If using the Stainless Steel Screen, install now. See page 13 for Screen Installation.

Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring

above the sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting

gasket, insuring each clamp tab is on the outside of the mounting gasket. While placing the face

ring on the gasket tuck the gasket in so no red shows. Hold the entire assembly together and flip

it over, place it on the non-abrasive surface as shown in the third picture below. Carefully position

the face ring so it is centered over the sound lens.

www.clarksynthesis.com

IN-WALL INSTALLATION

Diluvio

Underwater Speaker

™