Clark Synthesis TACTILE SOUND AQ339 Aquasonic Kurulum Kılavuzu - Sayfa 9

Konuşmacılar Clark Synthesis TACTILE SOUND AQ339 Aquasonic için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 20 sayfaları. Underwater speaker
Ayrıca Clark Synthesis TACTILE SOUND AQ339 Aquasonic için: Tamamlayıcı Kılavuz (4 sayfalar), Teknik Özellikler (1 sayfalar), Parça Listesi (1 sayfalar), Kullanıcı Kılavuzu (1 sayfalar), Referans Sayfası (1 sayfalar), Kurulum Kılavuzu (12 sayfalar), Kurulum Kılavuzu (3 sayfalar), Şartname (1 sayfalar)

Sayfayı Yazdır
Clark Synthesis TACTILE SOUND AQ339 Aquasonic Kurulum Kılavuzu
Loosen the nut on the wire clamp. With the mounting gasket facing up, place the wire clamp over
3
the speaker. The screw & nut should be facing down towards the speaker not the sound lens.
Nut
Wire Clamp
NOTE: If using the Stainless Steel Screen, install now. See page 13 for Screen Installation.
Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring
4
above the sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting
gasket, insuring each clamp tab is on the outside of the mounting gasket. While placing the face
ring on the gasket tuck the gasket in so no red shows. Hold the entire assembly together and flip
it over, place it on the non-abrasive surface as shown in the third picture below. Carefully position
the face ring so it is centered over the sound lens.
www.clarksynthesis.com
IN-WALL INSTALLATION
Diluvio
Underwater Speaker
™
9