Clark Synthesis TACTILE SOUND AQ339 Aquasonic Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 12 pages. Underwater speaker
Également pour Clark Synthesis TACTILE SOUND AQ339 Aquasonic : Manuel complémentaire (4 pages), Spécifications (1 pages), Liste des pièces (1 pages), Manuel de l'utilisateur (1 pages), Fiche de référence (1 pages), Manuel d'installation (3 pages), Spécifications (1 pages), Manuel d'installation (20 pages)

IN-WALL INSTALLATION

Use a wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened, the wire clamp

should be firmly seated in each clamp tab and the speaker should be secure. Pick up the assembly and

insure it is still properly centered in the face ring. If not, loosen the wire clamp and adjust.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using

a wire puller. Leave 10 to 12 ft. of speaker wire in the niche to allow for easier access during future

servicing of the speaker. Place the speaker inside the light niche.

Note: In actual applications, the niche will already be mounted in the wall of the pool.

Carefully set the lock tab located on the bottom of the face ring behind the receiving plate located on

the bottom of the niche. Align the bolt/rubber washer on the face ring with the threaded receiving hole

on the niche. Attach the trim ring securely to the niche by gently tightening the bolt. You are now ready

to connect the speaker to your audio system.

www.clarksynthesis.com

Underwater Speaker