Clark Synthesis TACTILE SOUND AQ339 Aquasonic Kurulum Kılavuzu - Sayfa 9

Amplifikatör Clark Synthesis TACTILE SOUND AQ339 Aquasonic için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 12 sayfaları. Underwater speaker
Ayrıca Clark Synthesis TACTILE SOUND AQ339 Aquasonic için: Tamamlayıcı Kılavuz (4 sayfalar), Teknik Özellikler (1 sayfalar), Parça Listesi (1 sayfalar), Kullanıcı Kılavuzu (1 sayfalar), Referans Sayfası (1 sayfalar), Kurulum Kılavuzu (3 sayfalar), Şartname (1 sayfalar), Kurulum Kılavuzu (20 sayfalar)

Sayfayı Yazdır
Clark Synthesis TACTILE SOUND AQ339 Aquasonic Kurulum Kılavuzu
IN-WALL INSTALLATION
Use a wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened, the wire clamp
4
should be firmly seated in each clamp tab and the speaker should be secure. Pick up the assembly and
insure it is still properly centered in the face ring. If not, loosen the wire clamp and adjust.
Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using
5
a wire puller. Leave 10 to 12 ft. of speaker wire in the niche to allow for easier access during future
servicing of the speaker. Place the speaker inside the light niche.
Note: In actual applications, the niche will already be mounted in the wall of the pool.
Carefully set the lock tab located on the bottom of the face ring behind the receiving plate located on
6
the bottom of the niche. Align the bolt/rubber washer on the face ring with the threaded receiving hole
on the niche. Attach the trim ring securely to the niche by gently tightening the bolt. You are now ready
to connect the speaker to your audio system.
9
www.clarksynthesis.com
Underwater Speaker