Clark Synthesis TACTILE SOUND AQ339 Aquasonic Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 3 pages. Underwater speaker
Également pour Clark Synthesis TACTILE SOUND AQ339 Aquasonic : Manuel complémentaire (4 pages), Spécifications (1 pages), Liste des pièces (1 pages), Manuel de l'utilisateur (1 pages), Fiche de référence (1 pages), Manuel d'installation (12 pages), Spécifications (1 pages), Manuel d'installation (20 pages)

AQUASONIC INSTALL- JANDY FACE RING

Carefully place the Jandy face ring (chrome side down) on a non-abrasive surface. Loosen the screws

until the retaining ring can be removed (see Photo #1 below). Remove the speaker from its box and

place the sound lens on the Jandy face ring (#2). Carefully spread the Jandy retaining ring so it can go

around the speaker's connecting stud (#3). Evenly align the retaining ring on the speaker.

CAUTION: Overspreading the retaining ring may break the ring.

Once aligned, tighten the screws in the retaining ring until they are secure (#4). Do not overtighten.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using a

wire puller (#5). Leave 10 to 12 ft. of speaker wire in the niche to allow for easier access during future

servicing of the speaker (#6). Place the speaker inside the light niche (#7).

Note: In actual applications, the niche will already be mounted in the wall of the pool.

www.clarksynthesis.com

Underwater Speaker- Jandy